Lulzbot Minis: Difference between revisions
Jump to navigation
Jump to search
NCMReynolds (talk | contribs) (Created page with "==General Info== thumb|right|Sandy & Ramon There are two [https://www.lulzbot.com/store/printers/lulzbot-mini Lulzbot Mini] 3D printers (Sandy & Ram...") |
NCMReynolds (talk | contribs) |
||
| Line 24: | Line 24: | ||
===Shutdown=== | ===Shutdown=== | ||
[[File:OctoPiShutdown.jpg|thumb|right|How to shut down OctoPi]] | |||
Before switching off at the switch, please shutdown Octopi by clicking on the 'power' icon on the top left and choosing "Shutdown system". Give the Raspberry Pi about 60s to shut down then switch the printer off at the switch on the front. | Before switching off at the switch, please shutdown Octopi by clicking on the 'power' icon on the top left and choosing "Shutdown system". Give the Raspberry Pi about 60s to shut down then switch the printer off at the switch on the front. | ||
Revision as of 16:27, 20 September 2021
General Info
There are two Lulzbot Mini 3D printers (Sandy & Ramon) at the Hackspace.
Specs
- Print Area: 152 mm x 152 mm x 158 mm
- Top Print Speed: 275mm/sec (10.8 in/sec) at 0.18 mm layer height
- Layer Thickness: From 0.05 mm to 0.50 mm
- Capable Materials: ABS, PLA, HIPS, PVA, wood filled filaments, Polyester (Tritan), PETT, bronze and copper filled filaments, Polycarbonate, Nylon, PETG, conductive PLA and ABS, UV luminescent filaments, PCTPE, PC-ABS, Alloy 910
- Filament Size: standard 3 mm
- Print Surface: Heated borosilicate glass bed covered with PEI print surface
Using
Powering on and access
The two printers are controlled by Octoprint. Power on the printer at the on/off switch on the front then after about a minute connect using the links below.
Shutdown
Before switching off at the switch, please shutdown Octopi by clicking on the 'power' icon on the top left and choosing "Shutdown system". Give the Raspberry Pi about 60s to shut down then switch the printer off at the switch on the front.