Wazer
Wazer
The wazer was the result of a combination of membership subscription fees grant from the Essex Community Foundation and a fundraising from the former chair of Rochford District Council, Cllr Julie Gooding.
The Wazer is used to cut things that cannot be cut in the much larger laser cutter.
It is worth checking that this is the optimum tool in accuracy and cost for your material. Whilst it can cut things like acrylic, either the CNC or laser may be more cost effective.
The machine costs £15ph for use and this covers wear on the bed, nozzle and the use of the supplied alluvial garnet which is quite expensive (You're cutting with tiny river rounded gem stones that can only be used once)
Materials that can be cut include:
- Most metals at varying thicknesses (inc titanium which cannot be cut on the CNC or via plasma due to toxicity) - Plastics (including polycarb which cannot be cut in the laser due to its refractive index & HDPE) - Carbon fibre and Fibreglass - Ceramics / Porcelain / Tiles - Glass / Borosilicate - Vinyl (Creates poisoness fumes) - Silicone / Foam /
Instructions for use / induction
Please read the instructions for use prior to the induction (Page 64 onwards)
Please leave the lid up when finished as this ensures the mechanics are not in a constantly humid atmosphere which will cause corrosion over time.
Common faults
banging from the pump
Water pressure too high. This may break the orifice. These are £300 so stop what you are doing(!)
abrasive emptying out under machine
Hose is either blocked or the insert has been pushed in too far. Ensure abrasive hose is set correctly (will be shown this in induction)
Click on the image above
nb, when blowing compressed air from the air compressor, it is best to disconnect this hose and use it to blow air through the hose only when the end attached to the cutting head has also been removed.
does not home
Abrasive not cleaned off by previous user and bellows are too stiff or thick with sludge to compress. Use hose to wash down all bellows.
does not home after abrasive cleaned off
Mark out of service and call maintainer
Wazer reports "close lid"
Magnetic reed switch in lid not triggering. Clear abrasive from door area and ensure lid is close enough to right hand side where sensor is (will show in induction)
Wazer screen does register SD card
Ensure SD card is ejected properly in windows or unmounted in Linux/Macs otherwise it will remain locked or read as corrupted
Wazer does not turn on
Ensure e-stop and switch are both in the on position. If both are correct, check the ip65 rated plug box adjacent to machine. If all are on, check water level, it must be level with bed for screen to switch on.
Wazer reports too full & empty
follow process for reducing/increasing water level
Maintenance
Troubleshooting & Maintenance Tips
Software
The software is cloud based and requires DXF or SVG to generate code.
specs
Cut area 305x460mm
Bed sized 330x485mm
Kerf 1.2mm
Abrasive Rate: 0.15kg/m
Max Speed: 1,500 mm/min
Positional Accuracy: 0.08 mm
Continuous cutting time 60mins between refills of abrasive hopper.
Hopper Capacity 13.5 kg
Abrasive used: 80 Mesh Alluvial Garnet
Cuts metal, glass, plastic, composites, tile, rubber, foam
Material Cut List Thickness and cutting speed
https://wazer.com/materials/materials-specs/#materials-table